Cable Tracing System AT-2004

Model AT-2004 Cable Tracing System includes receiver, load signal generator, transmitter, clamp-on transmitter accessory, cordsets and adapter. All components are fully fused, protected and intrinsically safe; and fit into a foam-lined carrying case that includes condensed operating instructions in its lid.

Model R2000 Receiver has two detectors in its tip which are tuned to pick up the electromagnetic signals ('short' mode) or electrostatic signals ('open' mode) generated by other components. The LEDs and sensitivity settings indicate the relative signal strength to allow easy detection of the signal source.

Model S2600 Load Signal Generator, when connected to an energized line, will draw a rapidly fluctuating current pulse from the source, causing the power line to emit an electromagnetic signal which is detected by the R2000 Receiver in the 'short' mode. These devices allow tracing of line-side conductors without power interruption or interference.

The T2200 Transmitter injects a signal into an unenergized conductor. If the conductor is broken (open), no current will flow, so the signal is present as a voltage pulse, which is detected along the conductor's length by the R2000's electrostatic detector ('open' mode). The signal will stop at the open.

When the A2201 Inductive Clamp is clamped around the energized line and plugged into the T2200 Transmitter, it will induce a signal onto the downstream (load) side to enable identification of equipment on that circuit.

Applications: